Got an Eclipse Opening Roof that’s stuck, slow, or not responding?

Eclipse Opening Roofs are a specific system with a specific set of failure points. Steve has spent years working on them – diagnosing and repairing the motors, pins, and control units that drive Eclipse Opening Roofs, anywhere in New Zealand.

Call 021 288 7700Email Steve
Low-angle view of modern building with slatted sunshade, railing, and blue sky with clouds.

What we diagnose and repair

Below are some of the common parts on the Eclipse Opening Roof we can replace. Don’t see your fault listed? Email us and we’ll take a look.

Electric motor with attached metal gear and wired connector on gray surface.

Motor / Bracket Assembly

Linear actuator mounted on a metal plate with mechanical linkage arms and black motor housing.

Linear Actuator

Metal pin with an attached white cylindrical sleeve on one end.

Pin Sleeve

Metal coil resistor with red and blue wire connectors mounted on a clear acrylic stand over a checkered surface.

Coil / Spring component

Rectangular gray metal electrical junction box with two cable connectors on one end.

Control Box

Two rectangular white control panels with blue and orange buttons labeled Open, Close, On, Stop, Auto, Rain.

Remote / Switch Pad

Anywhere in New Zealand, if it’s not doing what it should – call Steve on 021 288 7700

Or if you prefer, email a photo and we'll take a look.